Manual Modules MOCCA Morph Brush
Morph Brush Options
If this option is enabled, the tool's cursor is projected onto the mesh parallel to the computer screen. If the option is disabled, the cursor follows the direction of the geometry's surface starting from the point where you begin to paint.
If this option is enabled, the brush affects visible points only.
If this option is enabled, the brush affects selected points only.
Defines the radius of the morph brush's cursor.
Defines the strength of the morph brush's effect on the mesh.
Here you can choose from various types of fall-off that define how the tool's strength weakens from the cursor’s center to its edge. These are the same types of fall-off that are available for various other tools including the weight tool and the magnet. The following options are available:
Defines the width of the fall-off, measured from the center.
Defines how the tool's strength weakens from the cursor's center to its edge.
If Fall-Off is set to Curve, here you can create your own profile for the fall-off.
If you are using a pressure-sensitive input device such as a graphics tablet, here you can choose which tool property the pressure should affect. The following options are available:
Into this link field, drag and drop the morph tag containing the morph target you want to paint with.
If a morph tag is entered into the Morph Tag link field, here you'll find a list of all morph targets stored in the tag. Choose which target you want to paint with from this list.