QuickDrill Hole Group Management

Your Ad Here

Based on the analysis performed by Create Hole Groups, define the drill properties, such as: the XY location of each hole, the drilling processes, use existing cutters or define new ones and general properties.

The results of the analysis performed by Create Hole Groups are reflected in the Group Management dialog.

Note: The part containing the holes is now shown in transparent mode to display the holes.
Illustration:

Interaction

The Group Management dialog is displayed.

Define the parameters to be used to create the holes.
Press Apply .
Select Create TP from the QuickDrill Guide to create NC toolpaths based on the processes defined in the Group Management dialog. These toolpaths are displayed in the NC Process Manager.

Parameters

The Group Management dialog contains parameters (to be used to create the holes) in the following sections:

Return to Cimatron Index

Your Ad Here