The QuickDrill Guide, located by default on the right side of the Part Display, enables you to follow the logical steps of the drilling process, from start to finish.
How to close the QuickDrill Guide
The QuickDrill Guide steps are organized as follows:
|
|
Groups Creation: The system performs an analysis of the part based on the parameters entered into the Automatic Groups Creation dialog. This analysis divides the holes into groups according to hole type, geometry and attributes. |
|
|
Manage Groups: Based on the analysis performed by Create Hole Groups, define the drill properties, such as: the XY location of each hole, the drilling processes, use existing cutters or define new ones and general properties. |
|
|
Process Library: Define the drilling process for each type of hole. |
|
|
Cutter Library: Load the Cutter Library to show all cutters and to define new cutters. |
|
|
Create Toolpath: Export the geometry and the drilling process to a new NC document. |
How to close the QuickDrill Guide
To close the QuickDrill Guide, press the X button in the top right corner of the QuickDrill Guide.
