Access:

For Part entities: Select Edit / Copy Geometry from the main menu.

For NC Toolpath Trajectories: Select NC-Utilities / Copy TP Trajectory from the main menu.

• You can only move or copy an NC toolpath from within the NC application.

• You can only move or copy a complete toolpath and not part of it. If there are 3 procedures in a toolpath, all 3 have to be moved/copied.

• You can move or copy a previously moved/copied toolpath.

• You can move or copy 2.5 and 3 axis Mill toolpaths.

• All Reports may be generated for moved or copied toolpaths.

• The maximum number of moved or copied toolpaths is 200.

• To define a toolpath to be moved or copied, you must pick one point of it using either TPNODE or CLOSE.

• After moving or copying a toolpath, the new toolpath is assigned G ( ) status flag. All procedures within the toolpath are also assigned a G flag.

• You can use the Motion Editor, Simulator and Verifier on moved or copied toolpaths and procedures. You can also delete or suspend them.

• You can blank, unblank and toggle blank a moved or copied toolpath and procedure.

• You can save and load a template from a moved or copied toolpath and procedure.

• To rerun a moved or copied toolpath and procedure, redefine the geometric entities in the procedure.

• You can post process any moved or copied toolpaths and procedures.