Modify a PolyLine created in the Numerical Control (NC) application. In NC, the PolyLine entity is used as the output contour of the new NC procedures. These contours represent intermediate results of the NC algorithms and can be used as input for other NC procedures.
Notes:
This function is only relevant to NC users who wish to modify a PolyLine created in the NC environment.
To access this function, first switch from the NC to the CAD environment, and then run the function.
General Interaction
The following is the Feature Guide for Auxiliary Contours.
|
|
Remember: You can open the Feature Guide at any time on the graphic display area by right-clicking.
|
Required Step 1 
: Pick a single PolyLine to edit.
Required Step 2 
: Add / Edit / Remove / Move PolyLine points.
Optional Step 1 
: Set the PolyLine as either Open or Closed. If Open, define
the location of the open segment.
Detailed Interaction
