This menu is activated by right-clicking on the column header of the Process Manager.
Select the column name that you wish to be displayed in the Process Manager. Checked items are displayed.
The following popup menus are available from the Process Manager:
Process Manager Column Visibility Popup
Process Manager Column Visibility Popup
|
|
This menu is activated by right-clicking on the column header of the Process Manager. Select the column name that you wish to be displayed in the Process Manager. Checked items are displayed. |
|
|
This menu is activated by right-clicking anywhere on the graphic area or Process Manager. (If you are working within a procedure, however, right-clicking will open the Procedure Options.) You can select more than one item by using the Ctrl key and the mouse. Notes:
See explanations below. |
Create Toolpath: Create a 2.5, 3, 4, or 5 axis toolpath in which you will create one or more procedures.
Create Procedure: Create a set of milling cutter motions by selecting a milling technology, parameters, and geometry.
Edit Toolpath Parameters: Edit and/or modify toolpath parameters.
Edit Procedure Parameters: Edit and/or modify parameters or geometry selection of a procedure.
Select All, Cut, Copy, Paste, Delete Procedure/TP: Standard Windows operations for selecting items.
Show Motions, Hide Motions: Cutter motions can be hidden or displayed.
Toggle Motions Display: Hide motions that are currently displayed, and vice versa.
Refresh TP: Refresh the toolpath display.
Execute Procedure / Toolpath: When the procedure or toolpath is fully defined, execute to create the cutter motions.
Simulation - Remaining Stock: View the shape of the stock after the selected procedure.
Simulation - Wireframe: View executed cutter motions individually or by groups / layers.
Simulation - Advanced: The Verifier, Simulator and Machine Simulator are tools that enable you to check your NC toolpaths and procedures before implementing them on the shop floor.
Post Process: After a toolpath or procedure has been executed and cutter motions are created, create G-codes for milling machines.
Motions Editor: Manually edit cutter motions.
Save as Template: Save the toolpath or procedure for use in future documents.
Apply Template: Create a toolpath or procedure from a previously saved template.
Change Comment: Change the text that appears as a tool tip when holding the cursor over the flag of the procedure or toolpath name.
Change Cutter: Change the cutter used for the selected procedure.
NC Setup Report: Create a report that provides various information about the NC document currently active.
|
|
This menu is activated by right-clicking anywhere on the graphic area while creating or editing a procedure. These options are also available in buttons on the Work Mode Dialog. See explanations below. |
Save and Close: Suspend the procedure (close without executing.) Cutter motions can be calculated later.
Save and Calculate: Execute the procedure, save, and close. Cutter motions will be calculated.
Save Original: Close the procedure and save under a new name.
Cancel: Close the procedure without saving.
