icon.
The Motions Editor dialog will
have the following options:Once you have selected the motion blocks you want to edit, click the
Project icon.
The Motions Editor dialog will
have the following options:
Motions can be projected onto a Z plane. Use the Z Plane field to specify the Z level for projection. Use the All Blocks field to choose between the following options:
All Blocks on Z Plane: All selected blocks will be projected onto the specified Z plane.
All Blocks below Z Plane: All selected blocks below this Z level will be projected onto the specified Z plane.
The Procedure Defaults are displayed and can be edited for the motion connections.
Once the connection has been specified, you have the following options to proceed:
|
|
Cancel (close without saving) |
|
|
Reset (cancel all selections and start over) |
|
|
Calculate (calculate the new motions while the dialog remains open) |
|
|
Calculate & Close (calculate the new motions and close the dialog) |
After the new motions are calculated, the procedure will have a 
status
flag.
Important: Manual editing changes will be lost if you edit or re-execute the procedure!
