|
|
Mill horizontal and/or vertical areas (divided by a slope angle) using different machining technologies. |
Notes:
Check mark the Horizontal Areas and Vertical Areas parameters to display additional parameters.
If multiple cutters are defined for the procedure (in the Cutters & Holders parameter table), additional overlap parameters are displayed in the Tool Trajectory table. These parameters define the type of overlap (if any) between the tool pass of one cutter and that of another cutter. These overlap parameters are Horiz. Cutters Overlap and Vert. Cutters Overlap.
Tool Trajectory parameters
Click on any item in the menu below for
an explanation.
(Depending on your choices, some parameters may not be available.)
|
|
|
General Notes about Parameter Tables.
Examples:
Mill horizontal area using spiral technology:
Mill horizontal area using parallel technology:
Mill horizontal areas using spiral technology and vertical areas using layers technology:
