Mill all areas using either Parallel, Spiral or Layers machining.
|
|
Mill all areas using either Parallel, Spiral or Layers machining. |
Note:
If multiple cutters are defined for the procedure (in the Cutters & Holders parameter table), an additional overlap parameter is displayed in the Tool Trajectory table. This parameter defines the type of overlap (if any) between the tool pass of one cutter and that of another cutter. This overlap parameter is Horiz. Cutters Overlap.
Tool Trajectory parameters
Click on any item in the menu below for
an explanation.
(Depending on your choices, some parameters may not be available.)
|
|
|
General Notes about Parameter Tables.
