Machine one pass along all internal sharp corners in the part, as well as areas with radius of curvature smaller than the cutter radius. The results of this procedure are clean and smooth internal corners.
|
|
Machine one pass along all internal sharp corners in the part, as well as areas with radius of curvature smaller than the cutter radius. The results of this procedure are clean and smooth internal corners. |
Note:
If multiple cutters are defined for the procedure (in the Cutters & Holders parameter table), an additional overlap parameter is displayed in the Tool Trajectory table. This parameter defines the type of overlap (if any) between the tool pass of one cutter and that of another cutter. This overlap parameter is Cutters Overlap.
Tool Trajectory parameters
Click on any item in the menu below for
an explanation.
(Depending on your choices, some parameters may not be available.)
|
|
|
General Notes about Parameter Tables.
