When a by-pass is created and the tool is on a section of this by-pass, additional tool location parameters become available to give you even more control over the route of the by-pass.
These parameters are:
Divert the by-pass section so that it passes through an indicated point.
Press the Move
Thru Indicated Point button 
.
Pick a point through which the by-pass section will be diverted.
The by-pass section is updated to include the new location.
Divert the by-pass section so that it passes along the tool axis.
Enter a number, or use the spin buttons, to change the location of the tool along its axis.
The by-pass section is updated to include the new location.
Divert the by-pass section so that it passes through an X,Y,Z location.
Enter a number, or use the spin buttons, to change the X,Y,Z location of the tool.
The by-pass section is updated to include the new location.
