These parameters enable you to set user-defined Post Processor parameters.
This branch is displayed only if it is pre-defined by your Cimatron
Provider.
For Cimatron
Providers: The Provider
defines which parameters are included in the Basic
state and also the parameter names, using the following
controls:
The User Parameters branch enables you to define the level of control over its use and over the display of the parameters in the branch. The following branch options are available:Basic and Advanced - Basic is the default option.
The Advanced option displays all the parameters in the branch and enables full control over them. It is most likely that you will not need to display this state, as the specific parameters that are supported by your Post were included in the Basic state by your Cimatron Provider.
|
|
|
The Basic option displays the parameters defined by your Cimatron Provider as tailored for your Post requirements. An example of the Basic set of parameters (as defined by your Cimatron Provider) is shown below:
