This parameter appears in:

Collapsing

Machining By

The way the cutter rises after completing a milling pass.

For volume milling, spiral or stock spiral cutting procedures that contain both rough and finish motions.

Note: Corner Milling options vary depending on the procedure. Volume Milling, Spiral or Stock Spiral Cutting, 3D:

Corner Milling

The modals for this procedure are different. If Mill Finish Pass is checked, then the Corner Milling modals must be applied to all motions, or to the rough motions only. The modals are:

• Rough+Finish External Round

• Rough+Finish Round

• Rough Round All

• Rough Round Loops

For volume milling, spiral or stock spiral cutting procedures that contain both rough and finish motions.

Note: Corner Milling options vary depending on the procedure. Volume Milling, Spiral or Stock Spiral Cutting, 3D:

Corner Milling

The modals for this procedure are different. If Mill Finish Pass is checked, then the Corner Milling modals must be applied to all motions, or to the rough motions only. The modals are:

• Rough+Finish External Round

• Rough+Finish Round

• Rough Round All

• Rough Round Loops

For volume milling, spiral or stock spiral cutting procedures that contain both rough and finish motions.

Note: Corner Milling options vary depending on the procedure. Volume Milling, Spiral or Stock Spiral Cutting, 3D:

Corner Milling

The modals for this procedure are different. If Mill Finish Pass is checked, then the Corner Milling modals must be applied to all motions, or to the rough motions only. The modals are:

• Rough+Finish External Round

• Rough+Finish Round

• Rough Round All

• Rough Round Loops

For volume milling, spiral or stock spiral cutting procedures that contain both rough and finish motions.

Note: Corner Milling options vary depending on the procedure. Volume Milling, Spiral or Stock Spiral Cutting, 3D:

Corner Milling

The modals for this procedure are different. If Mill Finish Pass is checked, then the Corner Milling modals must be applied to all motions, or to the rough motions only. The modals are:

• Rough+Finish External Round

• Rough+Finish Round

• Rough Round All

• Rough Round Loops

If All Loops is used for Corner Milling, which implements high speed cutting, specify the maximum radius of the loops used to connect tool motions.

Available for Spiral Cutting, Outside In milling.