Add cooling items from the Catalog to the cooling channels.
Important: Make sure that the required assembly is activated before using this operation.
Note: Once the cooling items have been added, they can easily be edited or deleted.
General Interaction
The general interaction is similar to that for adding mold parts. The only difference is the dialog displayed during the required step 1.
Required Step 1 
Select a cooling component.
The Add Cooling Item dialog is displayed:
Browse to the required catalog location.
The Add Cooling Item sub-category is automatically displayed. Select the appropriate sub-category of the component.
The items in the sub-category group are displayed. Select the component item.
Press the
Show
Data button 
to choose the Catalog
parameters for the selected component item, or press OK
to position the mold part (Required
Step 2) or press the Cancel
button 
to exit.
If you pressed the Show
Data button , the Show
Data dialog is displayed. This dialog enables you to select a specific
set of pre-defined component parameters from the Catalog
parameter table.
The remaining interaction is identical to that for adding mold parts.
Press OK or Apply 
in the Feature
Guide to complete the function.
In the example below, a cooling component (in this case a nipple) has been added to the cooling channels.
