Pick dimensions which will be defined in the catalog table of the document and used for the creation of table driven documents.
This is the first stage in a wizard that guides you through the process of saving a part as a Catalog Part.
Reminder: To explain the use of this function, we are saving the pin, shown below, as a catalog part.
General Interaction
The Attach Names to Columns dialog is displayed:
This stage consists of the following steps:
Picking the dimensions that will be added to the catalog.
Setting the dimension attributes (Primary or Secondary Dimensions).
Defining the dimension order in the catalog table.
Selecting the Approval Options
The following approval options are available:
|
Apply |
Save the current status of the dimension definitions. The Primary and Secondary dimensions are saved, in the order they appear in the dialog. New dimensions are not saved until the Save button is pressed at the end of the process. |
|
Back |
Return to a previous stage. |
|
Next |
Go to the next stage in saving a part as a Catalog part. |
|
Cancel |
Exit the process without saving. |