Connect Component - Perpendicular

Position the selected components so that they are perpendicular to each other.

Required Step 1

Select the component entities to be connected. If you select a second entity from the same component, your second selection will replace the first.

Valid inputs are curves, points and surfaces in any combination. For example:

Notes:

• A connect relation will not be created between two components of the same sub-assembly when the assembly is active.

• A connect relation will not be created if none of the selected components belongs to the active assembly.

Required Step 2

Set parameters. In certain cases, you can use Alignments to specify the connect solution required.

Curve/Curve

Curve/Surface

Surface/Surface

Press in the Feature Guide to preview the result.

If this is the final result, press OK or Apply in the Feature Guide to complete the function.

Optional Step 1

Setting the coordinate system rotation parameters is only available when positioning a component specific UCS (User Coordinate System) to another component specific UCS.