| xPC Target | |
www.kxcad.net Home > CAE Software Index > MATLAB Index >
AD12-64(PCI) Digital Output block
xPC Target Library for Contec
Hardware Output | Block Input Data Type | Scaling |
|---|---|---|
TTL | Double | < 0.5 = TTL low |
Enter a vector of numbers to specify the output channels. For example, to use the first and third digital output channels enter
[1, 3]
The channel numbers can occur in any order. Number the channels beginning with 1 even if the board manufacturer numbers them beginning with 0. The maximum allowable channel number is 4.
The reset vector controls the behavior of the channel at model termination. Enter a scalar or a vector that is the same length as the channel vector. If you specify a scalar value, that setting is used for all channels. If you specify a value of 1, the corresponding channel is reset to the value specified in the initial value vector. If you specify a value of 0, the channel remains at the last value attained while the model was running.
The initial value vector contains the initial voltage values (0 or 1) for the output channels. Enter a scalar or a vector that is the same length as the channel vector. If you specify a scalar value, that value is the initial value for all channels. The channels are set to the initial values between the time the model is downloaded and the time it is started.
Enter the base sample time or a multiple of the base sample time.
If only one board of this type is in the target PC, enter
-1
to automatically locate the board.
If two or more boards of this type are in the target PC, enter the bus number and the PCI slot number of the board associated with this driver block. Use the format [BusNumber, SlotNumber]. To determine the bus number and the PCI slot number, type
getxpcpci
The Device ID of this board is 8143.
| | Contec AD12-64(PCI) Digital Input | Contec AD16-16(PCI)E | |
© 1984-2007 The MathWorks, Inc. • Terms of Use • Patents • Trademarks • Acknowledgments