xPC TargetAccessing CANdb DBC Format Databases from xPC Target   Softing CAN-AC2-PCI with Philips SJA1000 FIFO Setup
  

CAN FIFO Blocks for the CAN-AC2-PCI with Philips SJA1000 CAN Controller

www.kxcad.net Home > CAE Software Index > MATLAB Index >



The driver blocks described here support the CAN-AC2-PCI using FIFO mode. The Philips SJA1000 chip is used as the CAN controller in this configuration and supports both standard and extended identifier ranges in parallel. The driver block set for this board is found in the xPC Target I/O block library in the group CAN/Softing.

The third block group, CAN-AC2-PCI SJA 1000, contains the FIFO mode subgroup.

The highlighted group contains all driver blocks available for FIFO Mode CAN.

  

Accessing CANdb DBC Format Databases from xPC Target Accessing CANdb DBC Format Databases from xPC Target Softing CAN-AC2-PCI with Philips SJA1000 FIFO SetupSofting CAN-AC2-PCI with Philips SJA1000 FIFO Setup

© 1984-2007 The MathWorks, Inc. • Terms of Use • Patents • Trademarks • Acknowledgments