xPC Target

Bittware Audio-PMC+

Board

BittWare Audio-PMC+

xPC Target Library for Bittware

The Audio-PMC+ board is an audio board with 8 I/O channels.

xPC Target supports this board with these driver blocks:

Block parameters for the input and output blocks appear the same.

Board name	Audio-PMC+
Manufacturer	BittWare
Bus type	PCI
Access method	Memory mapped
Multiple block instance support	No
Multiple board support	No

Input and output are in the form of the Signal Processing Blockset frame signal type when the frame is larger than a single sample.
The analog input block outputs a double or 32 bit integer frame of data.
The Audio-PMC+ board performs acquisition simultaneously for all the selected channels in a model.
The analog output block is dynamically typed. The integer or double data type is taken from the connection instead of a block parameter.

The Audio-PMC+ daughter board might come from BittWare with jumpers installed to boot from an onboard ROM. You must remove these jumpers, as follows:

With the Audio-PMC+ off the carrier board, look for 6 pairs of pins along one edge. For proper operation with xPC Target, none of the pairs should be jumpered.
If there are any jumpers present, remove and then reinstall the jumpers with only one pin connected. Leave the other side of the jumper hanging. Leaving the jumpers like this will provide you with the jumpers if you want to use the board in ROM bootable mode at some future time.

Running Models with BittWare Blocks

Bittware Audio-PMC+ Analog Input