p-428

428

User Guide

Chapter 20: Motion Settings for a Multiple Joint Object

20

To set the Pose shown in the diagram below, you

have to move Uni-Scale E as well.

IMPORTANT: To make changes to the Point

you have set, be sure to turn on the [Auto Key]

check box and place the Sequence Cursor at

the same position as the Sequence Key Point

that is to be changed.

If the Sequence Cursor is not at the second Sequence

Key Point, click the Sequence Key Point to place the

Sequence Cursor there.

4. Turn on the [Auto Key] check box in the upper left

of the [Motion] window.

5.  Select Uni-Scale E in the lower-left Joint Selection 

box and drag the Sequence Joint Value slider up to

1.20.

Because the joint value was changed, a Motion

Point for Uni-Scale E is automatically created. The

Motion Point is created so that it follows the second

Sequence Key Point, since the Sequence Cursor is

set at the same position as the Sequence Key Point.

You have
nished recording the second Pose.

Since the [Auto Key] check box is currently on, lets

make the Motion setting for the third and later Poses

with this check box on.

Making a Motion Setting with

the Auto Key Check Box On

Now, lets continue to make the setting and start from

the third Pose.

The ow is as follows:

1. Move the Sequence Cursor

2. Set each Pose (each joint value)

3. Sequence Key Points are created automatically

Recording the Third Pose

3. Stretching out

In the third Pose, the arm has just stretched out.