Transfer Attributes - This option enables the transfer of Name, Layer & Color information. 

 

Read Blanked Parts - By default TransMagic does not read Blanked or "Hidden" entities from a UG file as these are typically construction geometry and other geometry not necessary to represent the main part or assembly. However, to read Blanked entities, check this option. 

 

Don't Read Invisible Layers - By default TransMagic does not read Invisible Layers. If you want to read entities from Invisible Layers into TransMagic, un-check this option. 

 

Resurface Splines - By default TransMagic will re-create erroneous spline surfaces that are common in some Pro/E file. Though there is no reason to disable this option, you may. Disabling this option will cause TransMagic to read in the erroneous spline surfaces. 

 

Read Free Curves - By default TransMagic reads in Free Curves (wire-frames). To disable the reading of wire-frame entities, un-check this option. 

 

Read Free Points - By default TransMagic does not read in free points. To read in Free Points check this option. 

 

Apply Tolerance Attributes - Sometimes the kernel behind Unigraphics, Parasolid, will allow tolerances too large for some formats. If you read in a UG file, write it out to another format, and the importing application has problems bringing that file in, then you can un-check this option, re-read the UG file and re-write it out. This will often cure this tolerance anomaly. 

 

Reset Defaults - Click this button to Reset to TransMagic default settings for UG Read. 

Return to TransMagic Index