In rapidformXOR view, if you right click you can see the pop up menus. The pop up menu appears based on the mode and current view.

If you are currently in viewing mode and right click the mouse, you get the following menu.

 

 

·   Zoom Fit - If selected, makes the model fit to the whole viewing window.

·   Zoom Area - If selected, zooms the viewing area into a selected rectangular region.

·   Zoom PIP – If selected, you can enlarge a view at the mouse position.

·   Align View – If selected, you can align the view with respect to the selected plane.

 

If you are in sketch mode and if you right click the view, you can see the following pop up menu.

 

·   Snap On Entities - If selected snap is shown while drawing entities.

·   Snap On Polylines – If selected snap is shown on polyline entities.

·   Show Constraints - If selected, sketch constraints are displayed.

 

If you are not in any mode and if you right click the view, you can see the following menu.

The pop up menu depends on the entity you selected. If you select an edge and right click you will get All-Edges. Selecting this option is similar to selecting Select > All from the menu.

 

·   All - Curves - If selected, all curves are selected.

·   None - If selected all curves are deselected.

·   Inverse – If selected, inverse of the current selection is selected.

 

The properties of any entity can be viewed by double clicking the entity. When you double click the entity properties of the entity are displayed. When there are more than one concentric points, it would be difficult to select one point and modify the properties. In such cases, if you click and hold the left mouse button and release you can see the pop up menu

 

 

 

Click and hold on the center point of the above sketch. When you see three points, release the mouse button. You can see the following pop up menu. You can select one entity and modify the properties in the properties window.