Revolve add or remove material by revolving one or more profiles around a centerline.

1.

Create sketch as the below image.

2.

Click  button on the toolbar, or click Insert > Surface > Revolve.

3.

Select Base Sketch.

4.

Click OK.

·   Base Sketch – Select the sketch to revolve.

·   Profiles – Sketch profile.

<Revolve Loop 1>             <Revolve Loop 1, 2 & 3>

·   Axis – Select an axis in the graphics area to revolve the sketch about that axis.

·   Method - You can select the method to revolve.
      a) One Direction - Creates the revolve in one direction from the sketch.

b) Mid Plane - Creates the revolve in the clockwise and counter
          clockwise directions from the sketch plane, which is located at the
          middle of the revolve angle.

c) Two-Direction - Creates the revolve in the clockwise and counter

clockwise directions from the sketch plane. Set the Revolving Angle
and the Revolving Angle 2. The total of the two angles cannot
exceed 360 degrees.

·   Revolving Angle - Angle to make the revolve feature.