Create a 3-phase circuit: Page 6 - 9

Create a 3-phase circuit

Create a 3-phase circuit: Page 8 - 9

 

Create a 3-phase circuit: Page 7 - 9

Now you are ready to insert a 3-phase motor symbol.

1. From ACE:Main Electrical toolbar, click the Insert Component tool.
2. Click the Motor Control icon on the Insert Component dialog box.
3. Click the 3 Phase Motor icon in the JIC: Motor Control list.
4. Insert onto the center phase of the 3-phase bus.

To complete the circuit diagram, you can use the Trim Wire tool to remove the upper and lower wire segments. Then reconnect the wire from the fuse to the motor using the Insert Wire tool to complete the 3-phase circuit.