Topics in this section

• Coordinate Filters (Command Modifier)

  Combines X, Y, and Z values from different points to specify a single point

• Direct Distance Entry (Command Modifier)

  Locates the next point at a specified distance in the direction of your cursor

• FROM (Command Modifier)

  Locates a point offset from a reference point within a command

• MTP (Command Modifier)

  Locates the midpoint between two points

• TRACKING (Command Modifier)

  Locates a point from a series of temporary points

• Object Snaps (Command Modifier)

  Specifies a precise point at a location on an object

• Selection Modes (Command Modifier)

  Controls how you create selection sets