Checker Map

Material Editor > Maps rollout > Click a Map button. > Material/Map Browser > Checker

Checker map used for the tablecloth and (in a composite) for the floor of the ice-cream shop

The Checker map applies a two-color checkerboard pattern to the material. The default checker map is a pattern of black and white squares. Checker maps are 2D procedural maps. The component checkers can be either colors or maps.

Tip: Turning on Noise for a Checker map can be an effective way to create irregular patterns with a natural appearance.

Procedures

To create a Checker map:

Click a map button to assign a map.
Choose Checker in the Material/Map browser, and then click OK.

To change the color of one set of squares:

In the Checker Parameters rollout, click a color swatch to display the Color Selector.
Adjust the color.
Click Close.

To use a map for one set of squares:

In the Checker Parameters rollout, click a map button to assign a map to a color.

To soften the edge between the two checker colors:

In the Checker Parameters rollout, increase the value of Soften.

When Soften equals 0.0, there is a hard edge between the checker colors. Low positive values soften or blur the checker boundary. Larger Soften values can blur the entire material.

To swap the two checker components:

In the Checker Parameters rollout, click Swap.

Interface

Soften—Blurs the edges between the checkers. A little blurs a lot.

Swap—Switches the position of the two checkers.

Color #1—Sets the color of one of the checkers. Click to display the Color Selector.

Color #2—Sets the color of one of the checkers. Click to display the Color Selector.

Maps—Selects a map to use within the area of the checker color. For example, you could put an additional checkerboard within one of the checker colors.

The check boxes enable or disable their associated map.

Checker Map

See also

Procedures

Interface