LOAD – Data Selection
The LOAD command can be used in the Subcase Information section to select a static load set to be applied in linear static solutions.
LOAD = option
Argument |
Options |
Description |
|
|
option |
< SID > No default |
SID: |
Set identification of a LOAD bulk data entry or, if no LOAD bulk data entry exists with this SID, the set identification of FORCE, FORCE1, MOMENT, MOMENT1, PLOAD, PLOAD1, PLOAD2, PLOAD4, GRAV, RFORCE, and SPCD, bulk data entries. |
Only one LOAD entry can be present for each subcase.
A METHOD entry cannot be present in the same subcase definition as a LOAD entry.
If the SID referenced by the LOAD subcase information entry matches with the SID defined for a LOAD bulk data entry, the information on this entry alone is selected. However, if no LOAD bulk data entry has the referenced SID defined, any of the static load entries: FORCE, FORCE1, MOMENT, MOMENT1, PLOAD, PLOAD1, PLOAD2, PLOAD4, GRAV, RFORCE, and SPCD, which have this SID will be selected.
In versions of OptiStruct prior to 8.0, thermal loads were selected in the subcase information section using the LOAD data selector. In version 8.0, the TEMPERATURE data selector was added to perform this function. It is possible to revert to the old behavior mode by setting the LOADTEMP option to SHAREID in the OptiStruct Configuration File.
Go To
Alphabetical List of Subcase Information Entries