SHAPE - Output Request
The SHAPE command can be used in the I/O Options section to request altered shape output for a shape optimization.
SHAPE (format,type) = option
Argument |
Options |
Description |
|
|
format |
<HM, H3D, blank> |
HM: |
Results are output in HyperMesh results format (.res file). |
|
Default = blank |
H3D: |
Results are output in Hyper3D format (.h3d file). |
|
|
blank: |
Results are output in all active formats for which the result is available. |
||
|
|
|||
|
type |
<ALL, DES> |
ALL: |
Results are output in all simulations. |
| Default = DES |
DES, blank: |
Results are only output in the design history simulations. |
|
|
|
|||
|
option |
<YES, ALL, NO, NONE> |
YES, ALL, blank: |
Results are output |
| Default = YES |
NO, NONE: |
Results are not output. |
|
When the SHAPE command is not present, shape results are output.
Shape results are only available for shape, topography, and free-shape optimizations.
Outputting the shape results in all simulations allows analysis results to be plotted on the altered shape.
The frequency of this output is controlled by the DESIGN keyword on an OUTPUT definition or, if no OUTPUT definition exists with the DESIGN keyword, by the DENSRES I/O option.
Only formats that have been activated by an OUTPUT or FORMAT command are valid for use on this card.
Multiple formats are allowed on the same entry; these should be comma separated. If no format is specified, then this output control applies to all formats defined by OUTPUT or FORMAT commands for which the result is available. See Results Output by OptiStruct for information on which results are available in which formats.
Multiple instances of this card are allowed; if instances are conflicting, the last instance dominates.
Multiple instances of this card are allowed; if instances are conflicting, the last instance dominates.
Go To
Alphabetical List of I/O Options