Open bearing.sldprt.
In the FeatureManager design tree, right-click
Smart Feature 
and
select Edit in Defining Assembly.
Open bearing.sldprt.
In the FeatureManager design tree, right-click
Smart Feature and
select Edit in Defining Assembly.
A temporary assembly, bearing_ta.sldasm opens.
Click Edit Definition on the pop-up toolbar.
In the PropertyManager, click Configurator Table.
For bearing configuration NPD-28, use same screws and washer as for bearing configuration NPD-32.
Click OK,
then click 
.
On the ConfigurationManager
tab, double-click NPD-28
to see the updated configuration.
Save and close the assembly.
The temporary assembly disappears. The updated defining data is saved in the component document bearing.sldprt.
Congratulations! You have completed this lesson.