Pin - When the pin is in, selecting Apply
does not close the dialog box, except when the edited entity is a joint
derived from a mate. When the pin is out, the dialog box closes when you
select Apply. Allows you to define the joints and ratios for a coupler. Select a tab:
|
When Joint |
Specify the first revolute, translational, or cylindrical joint selected from the browser. |
|
First Rotates |
Only available if the first joint is a revolute or cylindrical joint. |
|
First Translates |
Only available if the first joint is a translational or cylindrical. |
|
First |
Enter the first of the two numbers that specify the motion ratio. If the ratio is 1:2, this value is 1. |
|
Joint |
Specify the second revolute, translational, or cylindrical joint selected from the Browser. |
|
Second Rotates |
Only available if the second joint is a revolute or cylindrical joint. |
|
Second Translates |
Only available if the second joint is a translational or cylindrical. |
|
Second |
Enter the second of the two numbers that specify the motion ratio. If the ratio is 1:2, this value is 2. |
|
Revert |
Causes the entity to revert to the state after the last change or at the start of the edit. |
Pin - When the pin is in, selecting Apply
does not close the dialog box, except when the edited entity is a joint
derived from a mate. When the pin is out, the dialog box closes when you
select Apply.