Base Profile >> Sketch Curve >> Constraint >> Length/Radius

• Base Profile >> Sketch Curve >> Constraint >> Length/Radius command make a constraints selected sketch curve's Length/Radius .

Step

Execute Base Profile >> Sketch Curve >> Constraint >> Length/Radius command as follows:

1. Select Base Profile >> Sketch Curve >> Constraint >> Length/Radius from the menu or click the corresponding icon on the Feature toolbar.

2. Pick a line sketch curve that will be constrained and then following dialogue will appeared.

If selected curve is line, Line section of dialogue is highlighted. otherwise, vise versa.

rapidform supports below two methods of constraint.

 case1: Using mouse drag, user can drag curves to constraint distance in the screen. with Ctrl key, user can move finely. with Shift key, rough control is enabled. 

  after dragging, in case of undesirable result, user can reset constraint by Discard. otherwise just click Done to take result.

 case 2: Input value user wants, In this case, Discard button is disabled .

3. Keep picking sketch curves to make them Length/Radius to each other.

4. Click Done on RMB menu.

Note

• During the operation, make sure that endpoint of curve is subject to change.
• If user wants to swap end point to start point, use Base Profile >> Sketch Curve >> Reverse command.
• Discard, Done on RMB menu is same as dialogue's one