Cleanup

This feature will delete duplicate points, circles, and lines within a given tolerance. CleanUp will also delete duplicate shapes (including splines) given that the shape is terminated at both ends (if it is open). The user simply selects which feature type (or types) to delete, sets the tolerance and clicks the OK button. The system will keep the feature with the lowest number.

Angular Tolerance

Available when the Lines selection is checked. This is the allowable deviation (measured in degrees) between two or more lines. Lines that fall within the number of degrees entered in the Angular Tolerance field will be considered duplicates of one another.

Tolerance

Maximum allowable deviation between two or more features. Measured in either inches or millimeters, depending on which was specified in the Document Control dialog. Features that fall within the number of inches/millimeters entered in the Tolerance field will be considered duplicates of one another. This will apply to both the feature size and location.

For example, if a 10mm circle is created at X0Y0, another 10mm circle at X1Y0, then an 11mm circle at X0Y0, only the circle at X0Y0 will remain if the tolerance is anything greater than 1mm.

Visible Workgroups

When checked, CleanUp will remove duplicate items from all visible workgroups.

Once CleanUp is finished, the user will be informed of the results.