Adjusting Current Phase Noise

To adjust the amplitude of the current phase noise mode (if the current phase noise mode is "Nothing," then this will have no effect on the material):

1. Display the Phase Noise palette and select which component to adjust by clicking in one of the indentations.
   
   
2. Move the mouse over the red ball in the Amplitude slider. The cursor changes to a double-ended arrow.
   
   
3. Left-click on the ball and drag right to increase the amplitude up to 1000.
   
   
4. Left-click on the ball and drag left to decrease the amplitude down to 0.
   
   
5. You can also click on the arrows at each end of the Amplitude slider to adjust the amplitude manually.
   
   

Copyright © 2005-2007, DAZ Productions