General Interaction
And edge/curve is selected which is used as a reference for creating a new draft face. Then a base face(s) is picked.
Required Step 1 
Pick an edge/curve and exit.
Required Step 2 
Pick the base face(s) and set the direction (opening mold direction).
Required Step 3 
Flip the arrow to indicate the draft direction (inside or outside) and enter the Draft Angle, Fillet On/Off, Radius, and Align with Base/Curve parameters.
When finished, press OK 
or Apply 
in the Feature
Guide to complete the function.
Two sets of faces, draft surfaces and fillet surfaces are created. The base surfaces are split by the fillets.
When completed, the Advanced Draft function will appear in the Feature Tree as follows:
