Cimatron IT to Cimatron E 7.0+ NC Procedure Finder

The table below shows the Cimatron IT procedure names and the equivalent procedure names in Cimatron E 7.0 (and above).

Cimatron IT Procedure Name		Cimatron E 7.0+ Procedure Name
		Main Selection	Sub Selection
3D STEP		Surface Milling	Legacy Procedures	3D Step
CLEANUP		Remachine	Legacy Procedures	All options
CURVE_MX		Contour Milling	Curve_MX 3x, 4x, 5x
DRILL		Drill	Drill 3x, 4x, 5x
DYNMC_MX		-	- (use Connection instead)
MILL_GO		-	-
OPTIMIZE HORIZONTAL		Surface Milling	Legacy Procedures	Horizontal Area Parallel
				Horizontal Area Spiral
				Horizontal Area Radial
OPTIMIZE VERTICAL		Surface Milling	Legacy Procedures	Vertical Area
PENCIL		Remachine	Legacy Procedures	Legacy Pencil
PLNGMILL		Volume Milling	Legacy Procedures	Plunge Mill
POCKET (FINISH)		2.5 Axes	Pocket Milling
POCKET (ROUGH)		2.5 Axes	Stock Spiral
			Parallel Cut
			Spiral Cut
PROFILE		2.5 Axes	Profile Open Contour
			Profile Closed Contour
			Profile Open by Plane
			Profile Closed by Plane
ROUGH_5X		-	-
RULED_MX		Flow Line	Ruled Surface 3x, 4x, 5x
SRFPKT (FINISH)		Surface Milling	Legacy Procedures	Pocket Milling
SRFPKT (ROUGH)		Surface Milling	Legacy Procedures	Stock Spiral - 3D
				Parallel Cut - 3D
				Spiral Cut - 3D
				Finish Radial Cut
SRFPRF		Surface Milling	Profile Open Contour
			Profile Closed Contour
SURCLR		Flow Line	Aiming Surface 3x, 4x, 5x
SURMILL		Flow Line	Part Surface 3x, 4x 5x
WCUT (FINISH)		Surface Milling	Legacy Procedures	By Layers
WCUT (ROUGH)		Volume Milling	Legacy Procedures	Stock Spiral 3D
				Parallel Cut 3D
				Spiral Cut 3D
ZCUT		Volume Milling	Legacy Procedures	Zcut Parallel
				Zcut Radial

Return to Cimatron Index