|
|
The cutter moves in spiral motions. In Spiral Vertical + All On Surface, all surfaces are milled on surface. In addition, the vertical areas are also milled in Constant Z down steps. |
Hints and tips for Cleanup procedures
Illustration of Vertical + All On Surface
How to create this procedure: (see Creating a Procedure and Procedure Guide for general explanation.)
For Technology, choose Remachine as the main selection, and Legacy Procedures / Spiral Vertical + All On Surf. as the subselection.
Choose the appropriate cutter.
Define the contours, part surfaces, and check surfaces.
Define the following Motion Parameters:
Define the Machine Parameters.
When finished, you can choose from the following Procedure Options:
(The options Save & Close and Save & Calculate are also available on the Procedure Guide.)
Notes:
To mill only vertical areas, using Constant Z down steps, choose the Remachine - Legacy Procedures / Only Vertical Area.
To automate the Cleanup procedure, choose Remachine sub selection Cleanup.
