The Tolerance & Surf. Offset branch enables you to define the level of control over its use and over the display of the parameters in the branch. The following branch options are available:Basic and Advanced - Basic is the default option.
Note: Only the Advanced option is available for Legacy procedures. However, if the contents of the parameter branch is the same for the Basic and Advanced options, only the Basic option is available.
Click on any item in the menu below for
an explanation.
(Depending on the procedure
you have selected, some parameters may not be available or other
parameters may be displayed.)
|
|
|
If a Micro Milling toolpath has been defined, an additional parameter is displayed. This parameter overrides the Max. Contour Gap definition in the Preferences.
The default option for this branch is Basic. This enables minimal control over the tolerances and surface offsets.
In the CurveMx 5x function, the only available option is Basic.
General Notes about Parameter Tables