Define the mode of entry to the start point of the toolpath.
This parameter is only displayed in Rough and ReRough procedures.
|
Optimized |
The entry mode is optimized to select the shortest machining time - plunging time (plunge length x plunge feed) is compared with slotting time (slot length x slot feed). | ||
|
By Length |
Define the maximum distance to search for a valid air plunge point. Enter this value into the parameter Max. Entry Length which is displayed when By Length is selected.
| ||
|
No Plunging |
Entry can only be performed using horizontal movements (slotting). If this is impossible, entry is cancelled. In this case, the Ramp Angle is given a value of 0.000 degrees. | ||
|
Drilling |
The entry movements are performed using drilling motions. In this case, the Ramp Angle is given a value of 90.000 degrees. |