Define the part locations within the mold, as part of the process of defining a mold configuration.
The available types of components are based on the initial parameters that you set while defining the Plate Set.
The following dialog is displayed:
Decide whether or not you wish to add components
to the mold configuration.
Use the check boxes to include or exclude components.
In some standard configurations, some of the components are mandatory
and others are optional.
In non-standard configurations, the plate is displayed without holes
and all the components are optional.
Press Finish to complete the mold configuration process.
Once you have finished defining the plate set, the results are twofold:
The core and cavity components are encased in the mold base.
|
The mold base |
The mold base in transparent view, showing the core and cavity components |
|
|
|
The assembly tree is updated to show the newly added mold plates.
|
The assembly tree before adding the mold plates |
The assembly after adding the mold plates. | ||||||
|
|
Note that the new plate entries consists of:
|
The active parts now need to be protruded from the cavity plate (K 20).
