Edit Layout Part:

Options and Results

Required Step 1

Pick the UCSs to be edited.

Required Step 2

Set the orientation parameters.

Note: To choose different UCSs, press the required step 1 icon again, and re-pick the UCSs.

These orientation parameters are displayed for the picked UCSs and relate to them globally (any change in the parameters will affect all the picked UCSs). Individual UCSs (within the picked group) can be edited by specifying values that differ from the general values.

Notes:

• The initial orientation is parallel to the main layout part coordinate system. These parameters consist of 1 translation (in the Z direction) and 3 rotations.

• The order of specifying rotations is extremely important and this will be shown in the interaction. For example:

Picked UCS Edit

This enables you to edit all the picked UCSs using global parameter values. In the example below, the X axis has been rotated 90 degrees, affecting the UCSs 12_1 and 12_2.

Note: Picked UCSs are denoted by .

Individual UCS (within picked group) Edit

Individual UCSs (within the picked group) can be edited by specifying values that differ from the general values. These, individually edited UCSs, display their orientation parameters within a dialog box attached to the UCS.

Notes:

• The initial orientation parameters are the same as those of the (edited) picked UCSs.

• Individually edited UCSs within a group are denoted by .

Any change in the parameters affect only the individual UCS (from the picked group).

Note: Each orientation parameter dialog box displays the following icons:

If this is the final result, press OK or Apply in the Feature Guide to complete the function.