Add a Slider from your catalog to your mold.
A slider is composed of several parts. These are kept in the catalog as an assembly and can be extracted as required. There is an interaction between the part sizes that you can select to make different groups of pins and also to remove components. At the end of this interaction, a sub-assembly representing the slider is created.
General Interaction
The general interaction is similar to that for adding mold parts. The only difference is the dialog displayed during the required step 1.
Required Step 1 
Select a slide unit.
The Add Mold Slide Units dialog is displayed:
Browse to the required catalog location.
The Slide Unit sub-category is automatically displayed. Select the appropriate sub-category of the component.
The items in the sub-category group are displayed. Select the component item.
Press the
Show
Data button 
to choose the Catalog
parameters for the selected component item, or press OK
to position the mold part (Required
Step 2) or press the Cancel
button 
to exit.
If you pressed the Show
Data button , the Show
Data dialog is displayed. This dialog enables you to select a specific
set of pre-defined component parameters from the Catalog
parameter table.
The remaining interaction is identical to that for adding mold parts.
Press OK or Apply 
in the Feature
Guide to complete the function.