Add screws from your catalog to your mold.
General Interaction
The general interaction is similar to that for adding mold parts. The only difference is the dialog displayed during the required step 1.
Required Step 1 
Select a screw component.
The Add Mold Screws & Bolts dialog is displayed:
Browse to the required catalog location.
The Screw sub-category is automatically displayed. Select the appropriate sub-category of the component.
The items in the sub-category group are displayed. Select the component item.
Press the
Show
Data button 
to choose the Catalog
parameters for the selected component item, or press OK
to position the mold part (Required
Step 2) or press the Cancel
button 
to exit.
If you pressed
the Show Data button , the Show Data
dialog is displayed. This dialog enables you to select a specific set
of pre-defined component parameters from the Catalog
parameter table.
The remaining interaction is identical to that for adding mold parts.
Press OK or Apply 
in the Feature
Guide to complete the function.