Add a Layout part. This is a preliminary layout which can be edited in later phases of the mold creation process.
The Layout Part dialog is displayed:
You
can either create a new layout part, or browse using the open document
icon 
, to add one of your own layout parts or select
one of the predefined layout parts supplied by Cimatron.
These predefined parts (inch. and mm.) are available under the following
folder: C:\Cimatron\CimatronE\Data\dat\Molddata\Layout-parts.
If you create a new layout part, set the units of measurement for the part.
Note: There will only be one recognized layout part per mold assembly.
Changes in the Tree structure after adding a Layout part
Once a layout part is defined the following occurs:
a Layout part is created in the Assembly Tree.
a Parting tab is created and contains the Parting Tree, which also contains the Layout part.
The Assembly tree before a layout part is added.
|
The Assembly
Tree, showing the Parting sub-assembly
and the Layout part. The latter
is created when a Layout part is defined. |
The Parting Tree. This is created
in the Parting tab
when a Layout part is defined. |
|
|
|
