Create the blank for the electrode.
Notes:
Only one Blank feature per electrode can be created. If the Blank function is invoked after a Blank has been created, the function will be invoked in edit mode.
This function is only available when an electrode document is active.
General Interaction
The following is the Feature Guide for Blank.
|
|
Remember: You can open the Feature Guide at any time on the graphic display area by right-clicking. |
|
Required Step 1 
:
Select the options and set the parameters for the blank.
Optional Step 1 
: Center To Selection.
Optional Step 2 
: Fit To Selection.
Optional Step 3 
: Mark the base of the blank.
Detailed Interaction
See Options and Results.
