Access: To
edit the BOM, either double-click
the BOM
table, or right-click the table and select Edit
This from the popup
menu. When the BOM feature guide is displayed, press
the Edit BOM table icon 
.
The following dynamic editing operations can be carried out on the BOM Table.
Column widths can be set dynamically from the BOM Table Editor dialog or from the BOM Table in the Drafting Sheet. In both these areas, drag the appropriate column walls to the required width.
Note: Column widths can also be set numerically using the Properties button of the Column Chooser dialog, which is accessed via the BOM Table Editor dialog.
To size the BOM columns dynamically, click on the column walls and drag them accordingly.
The BOM Table in edit mode.
In the gray area of the columns, select the column to be adjusted. The cursor changes.
Drag the column to the required width. Press OK.
The column width is updated in the BOM Table.
To size the BOM columns dynamically, click on the column walls and drag them accordingly.
The BOM Table in edit mode.
Select the column to be adjusted. The column is highlighted and the cursor changes.
Drag the column to the required width.
The new column width.
To move the BOM, select one of the 8 hot spots (one at each corner and one at each mid-point) and drag the BOM to its new location.
Note: If the hot spots are not displayed, highlight the BOM table by moving the cursor over it, and then do one of the following:
double-click the BOM table.
right-click the BOM table and select Edit This from the popup menu.
Example:
As you move the cursor over an individual the hot spot, it becomes highlighted. Pick a hot spot and drag the entire BOM table to the required position. These hot spots can be associated to reference entities, such as lines, arcs and points.
The BOM table is positioned as required.
