Availability CAMtastic! Document
(Menu) : Analysis » Re-load DRC Rules from PCB...

Description This command is used to load design rule constraint tolerances, where applicable, from the PCB design document into the PCB Design Check/Fix dialog of the current CAMtastic document.

Use After launching the command, the relevant design rule tolerances from the PCB document will be loaded into the Size (mils) column of the PCB Design Check/Fix dialog. The mapping of PCB design rule types to the corresponding DRC entries in the PCB Design Check/Fix dialog, are as follows:

Min. Annular Ring (Drill->Pad)...................Minimum Annular Ring

Min. Annular Ring (Pad->Mask)................Solder Mask Expansion

Min. Clearance (Pad->Pad).......................Clearance

Min. Clearance (Pad->Trace)....................Clearance

Min. Clearance (Trace->Trace).................Clearance

Min. Trace Width........................................Width

Notes If the current CAM document was generated from the Design Explorer-based PCB Editor, then after launching this command, the PCB document will be opened (if not already) and made the active document in the main design window.

Process CAMTASTIC:InfoLoadDRCRulesFromPCB