Availability CAMtastic! Document
(Menu) : Place » Drill » Create Drill(s)

Description This command is used to convert existing circular flashes to drill points.

Use After launching the command, the cursor will change to a square and you will be prompted to select flashes to include in the conversion. Simply position the cursor over a circular flash that you wish to include in the selection and click. Clicking away from an object allows you to drag a selection area, for including multiple objects in the selection. Selection is cumulative.

Continue adding flashes to the selection and then right-click when all required flashes have been selected. The selected flashes will be converted to drill points and new tool entries will be added in the Tool Table dialog, below any existing entries.

Continue to select further circular flashes for conversion to drill points or right-click or press ESC to exit.

Notes In order for this command to be available, make sure that you are in the NC Editor, rather than the CAM Editor. (Editor selection is carried out from the View menu).

Process CAMTASTIC:DrillConvertFlash

Parameters CommandMode=NC