You can edit the length or direction of a site boundary edge by editing site boundary properties.
To edit the length or direction of a site boundary edge:
Click on the lot line you want to edit.
Right-click and select Properties, or select Edit > Modify Elements > Properties.
To edit the length of the current segment, type the desired value in the Length edit box.
To edit the distance of the setback line from the lot line, type the distance in the Setback edit box.
To edit the angle of the current segment, make the appropriate changes in the Direction area of the Site Boundary Edge dialog. There are two methods of defining direction. The method that is available is the one that was used to draw the site boundary initially, or whatever is current on the Units of Measure page in your Program Settings.
If the Reference Angle Method is current, you can edit the direction of the segment by editing the value in the Angle edit box. If the Angle Bearing Method is current, you can edit the direction of the segment by editing the Forward Bearing or Back Bearing value.
In the When Editing area, select the appropriate Peg No. to adjust, as editing the length or angle of a segment will cause a peg to move.
Click OK.